12 Years Factory wholesale 32″ rubber glove-cotton linning Bahamas Manufacturer

Short Description:

Heavy duty rubber glove, made of 100% natural latex. 32″ length(82cm), smooth finish, seamless, cotton lining, left/right hand, 800g/pair, 50 pairs/case. Using for Isolater, dry box, blast cabinet, etc.


Product Detail

FAQ

Product Tags

we thinks What customers think, the urgency of urgency to act in the interests of a customer position of principle, allowing for better quality, lower processing costs, prices are more reasonable, won the new and old customers the support and affirmation 12 Years Factory wholesale 32″ rubber glove-cotton linning Bahamas Manufacturer, We are confident to make great achievements in the future. We are looking forward to becoming one of your most reliable suppliers.


Heavy duty rubber glove, made of 100% natural latex. 32″ length(82cm), smooth finish, seamless, cotton lining, left/right hand, 800g/pair, 50 pairs/case. Using for Isolater, dry box, blast cabinet, etc.

  • Previous:
  • Next:
  • FAQ Content




  • Here I am doing basic glass cutting on a scrap piece of glass, actually it’s a mirror. For much more videos about basic glass cutting, etc. see the playlist: http://www.youtube.com/playlist?list=PL4A57AB2EFB9566F9&feature=plcp

    Do not attempt to cut (pre) Tempered Glass, it cannot be cut and is designed to shatter to small pieces for safty purposes. You can cut (flat) Plate Glass.

    The “glass cutter” does not actually cut through the glass, it just scratches or “scores” it, so it should be called either a “glass scratcher/scorer” or a “tool of glass cutting”.

    The score is then used when you actually break or snap the glass along this “weakened” line (or even curves are possible). Technically, you try to “bend” both sides along the score downward to “open” (not compress) the crack up to the back side of the glass. In the vid. I show holding the piece of glass with my hands as a lot of people seem to do – especially with small pieces, but it’s safer to put the glass on a firm surface first and/or wear gloves.

    To remove the sharp parts after cutting the glass, I used some sandstone I found down by the river. Just about any stone or cement will do, just dont use something too hard like smooth quartz since it tends to just “glide” over the glass. Use both straight and circular motion with the stone at about a 45 degree angle to the glass to bevel it to a non-sharp/thin semi-round surface. It is good though to have an electric grinder or rotary tool like a Dremel incase the break leaves some sizeable bumps of glass areas that would be difficult to grind by hand. If you dont have that, perhaps a larger piece of smooth cement might work ok.

    Be sure to sweep up and vacuum any glass shards.

    Note you can use a flat rule made of metal, wood, or plastic to guide the glass cutter, but be sure its not too thin since you do not want to damage the “cutting wheel” (the part that scores the glass) if it came in contact with metal.

    About the tool I made; the ruler-straightedge with the rubber attached to the back. The rubber (or nylon) was cut from a bicycle inner-tube, and was attached with contact cement which is very sticky and somewhat flexible. This glue is sometimes called “rubber cement”. I got a tube for about $1. I also lightly scratched both surfaces of the rubber for better adhesion of the glue and for better “holding” ability on the glass. I guess you could also use some flat erasor type material too instead of the inner tube material. Silicone rubber or a thin coat or beads of dried caulking might be ok. Some tape can possibly be used to secure the straightrule, but you might have to clean up any residue left from the tape unless you put the tape right on the rule itself. When you cut the bicycle tube, avoid breathing the powder (usually talc or talcum), so rinse the tube segment with hot soapy water and let it dry.

    Keep the “scoring wheel” oiled. I just keep/store that end in a glass with some clear oil in it. I use cheap “mineral oil” from the dollar/drug store.

    Find some flat glass pieces and practice a bit on them so that you are prepared to cut glass when you need to.

    Here is a good website about glass cutters, care and use:

    http://www.freepatternsforstainedglass.com/your-glass-cutter.html



    directed by Shin Sang-ok
    A husband (Kim Seung-ho) who works at an insurance company and is called ‘Romantic Papa’ by his five children lives happily with his wife (Ju Jeung-nyeo) and family. The eldest daughter, Eum-jeon (Choe Eun-hui), graduates from college and marries Jeon U-taek (Kim Jin-gyu). The eldest son, Eo-jin (Nam Gung-won), pretends to be going to college but works behind the scenes trying to prepare to be a movie director. The second daughter, Gop-dan (Do Geum-bong), is a college student, while as the second son Bareuni (Shin Seong-il) and the youngest daughter Ippeuni (Eom Aeng-ran) are high-school students. Although the father’s salary is barely enough to feed the whole family, he takes care of his family with an optimistic nature and a penchant for laughter. However, due to his old age, the insurance company lays him off. Worried about disappointing his family, he doesn’t tell them the news. Although his sons and daughters eventually find out, they pretend not to know while trying to figure out a way to console their father. On his birthday, the entire family gets together and has a wonderful time.

    자식들에게 `로맨스빠빠’로 불리는 보험회사 사원인 그(김승호)는 아내(주증녀), 2남3녀의 자식들과 함께 단란한 가정을 꾸리고 있다. 장녀 음전(최은희)은 대학을 졸업하고 관상대에 다니는 전우택(김진규)과 결혼한다. 큰아들 어진(남궁원)은 대학에 다닌다고 부모들을 속이고 영화감독이 되기 위해 촬영현장에서 일한다. 둘째딸 곱단(도금봉)은 여대생이고, 둘째 아들 바른이(신성일), 막내 딸 이쁜이(엄앵란)는 고등학생이다. 대식구들의 생활을 꾸리기에 그의 적은 월급은 빠듯하지만, 낙천적인 그는 웃음으로 가족들을 감싼다. 그러나 보험회사에 감원 바람이 불면서, 건실한 사원이었던 그는 나이가 많아 감원대상이 되어 퇴직한다. 그는 가족들이 실망할까봐 자신이 실직했다는 것을 말하지 못한다. 아들, 딸들은 이 사실을 알아차리지만 모르는 척 하고 아버지를 위로할 방법을 찾는다. 아버지의 생일날, 온 가족이 모여 행복한 시간을 보낸다.

    Send your message to us:

    INQUIRY NOW
    • [cf7ic]

    Related Products

    INQUIRY NOW
    • [cf7ic]