8 Years Manufacturer Isolater rubber sleeve Marseille Supplier

Short Description:

14″ length (35cm), black, smooth finish, seamless, no cotton lining, 350g/pair, cuff perimeter:61cm, double layer thickness:2.2mm. 40 pairs/case. Net weight: 12.8kg/case, gross weight: 13.8kg/case. It can be suitable for sand blasting machine, dry box, isolater operation for arm protection.

Product Detail

FAQ

Product Tags

Our company since its inception, always regards product quality as enterprise life, continuously improve production technology, improve product quality and continuously strengthen enterprise total quality management, in strict accordance with the national standard ISO 9001:2000 8 Years Manufacturer Isolater rubber sleeve Marseille Supplier, We sincerely welcome domestic and foreign merchants who calls, letters asking, or to plants to negotiate, we will offer you quality products and the most enthusiastic service,We look forward to your visit and your cooperation

Previous:

Next: Lowest Price for 14″ rubber glove with cotton linning-rough finish Supply to Ottawa

FAQ Content

anti-erode latex foot covers

Anti-erode Latex Socks

Anti-erode Rubber Foot Covers

In this video, I show how to fix a common problem with the blower door actuator on a 2010 Ford F-150 XLT. Here is the part that I installed into the truck. http://amzn.to/2f0Vgue

2003- 2008 Blend Door Actuator Ford F-150

http://amzn.to/2oVwtNh

2009- 2014 Blend Door Actuator Ford F-150 (THIS IS THE MODEL I USED)

http://amzn.to/2f0Vgue

2015- Present

http://amzn.to/2qvKL4s

Dashboard Plastic Remover Tool:

http://amzn.to/2pVlmUE

Note: Make sure this fits within your model. I know its hard to find the parts sometimes, so I hope you use these links above as a guide to finding your actuator.

This F-150 would only blow cold air because the actuator for the blower door went out. Before I went this far to replace the part I started a few diagnoses: tested the air conditioner, went under the hood to see if the heater core hoses were hot, and check the internet if this was a common issue. Sure enough, every test lead to a faulty actuator.

The hardest part was jamming my hand through the glove box. In order to get to the 5/16in screw on the bottom, I had to go through the glove box while my left hand was in the dash to help assist. Once I got the screw out it was fairly simple.

Installing the new unit took a little bit of wiggling in there because the actuator and door need to be lined up. It can only fit one way. The gear is keyed for this reason. Once installed, connect the power cord, install the two screws that hold the unit down, and put the dash all back together.

This process took about 45 minutes to complete. After the install I was able to change from hot to cold with ease.

Thanks for watching:
Subscribe- http://goo.gl/nD3r4v
Like
Comment
Enjoy

http://enfig.wordpress.com/2010/02/03/audi-ipod-guide-a4-2007-2008/