Excellent quality for 26″ Industrial rubber glove-rough finish Tanzania Factory

FAQ Content

Be safe! One viewer mentioned the importance of eye protection, I feel like an idiot for forgetting this. Don’t take any chances, please USE PROTECTIVE EYEWEAR!

Things you’ll need:
-rubber gloves
-eye protection
-well ventilated area
-Radio Shack PCB Etchant Solution ($12-15)
-glass jar and lid
-piece of string or cord (to suspend the knife)
-nail polish
-nail polish remover
-600+ grit sandpaper
-paper towels
-a safe working surface (newspaper, cardboard, etc.)

In this video I demonstrate how to acid etch a knife blade. It’s a simple and easy way for you to add your own creative customization to your knife. This is my first time attempting this project, it was successful, so I am sharing the process. DO THIS AT YOUR OWN RISK. I am leaving a few important tips below, but know that you can screw up your knife. That’s why I did it on a $18 knife this time. Besides that, have fun!

***Important tips***

If you are etching a folding knife…
1. Make SURE to coat (with nail polish) in and all around the pivot hole! If any of that surface is etched, it will affect the action of the knife, and probably ruin it.
2. Make sure to coat the locking surfaces, where the liner or frame lock touches the blade, same goes for a back lock, whatever kind of lock. If you’re unsure, just coat it!

Coat the cutting edge WELL!

Notes about the video: I sped up a lot of it because I didn’t necessarily want to cut out the parts I did the work, yet I didn’t want the video to end up 30 minutes long! If you have any questions at all, ask in the comments, I’ll get back to you. Hope this helps, thanks for watching!

Dispose of your etchant solution safely. Either neutralize it completely, or contact your local waste management office and ask what to do with it. Don’t risk the environmental damage and possible damage to your pipe.

http://www.partselect.com/PS1146950-Frigidaire-134511600-Drive-V-Belt.htm?SourceCode=15 Click on below for a lot more info on this part, set up guidelines and a lot more.

This particular Drive V Belt is particular to Frigidaire made manufacturers including Gibson, Kelvinator, Tappan, White-Westinghouse, and Westinghouse. To obtain a drive belt particular to your design, stop by http://www.PartSelect.com.

If your washing device is obtaining any of these signs or symptoms, then replacing the drive belt could remedy your equipment problem.
one) Spin cycle not functioning appropriately
2) Smelled like burning rubber
3) Truly loud squeaking in the course of the spin cycle

PartSelect Section Amount: PS1146950
Frigidaire Section Amount: 134511600

Instruments used for this repair/substitution:
one) Putty Knife
2) Phillips Screw Driver

Get design-particular repair enable from PartSelect.com. Master how to troubleshoot, diagnose and repair your equipment with consumer-generated set up guidelines, hundreds of action-by-action repair movies, and our Quick Repairman. If you’ve received an equipment problem, we can enable http://www.partselect.com/Quick-Repairman.htm