Good Quality 12″ rubber glove with cotton linning-rough finish supply for Colombia
Short Description:
Heavy duty rubber glove, made of 100% natural latex. 12″ length(31cm), rough finish, seamless, cotton lining, left/right hand, 210g/pair, 120pairs/case. Using for Isolater, dry box, blast cabinet, glove box, etc.
Product Detail
FAQ
Product Tags
Reliable quality and good credit standing are our principles, which will help us at a top-ranking position. Adhering to the tenet of "quality first, customer supreme", Good Quality 12″ rubber glove with cotton linning-rough finish supply for Colombia, We warmly welcome customers from all over the world for any kind of cooperation with us to build a mutual benefit future. We are devoting ourselves wholeheartedly to offer customers the best service.
Heavy duty rubber glove, made of 100% natural latex.
12″ length(31cm), rough finish, seamless, cotton lining, left/right hand, 210g/pair, 120pairs/case.
Using for Isolater, dry box, blast cabinet, glove box, etc.
FAQ Content
Be cautious when holding key components that have sensitive contact areas. If you want to be extra cautious you can use tech grade ESD gloves. I recommend ESD Nitrile gloves that have microtextured fingertips that provide excellent grip on all surfaces. 100% nitrile gloves contain no natural rubber or silicone and meet stringent requirements for particles and extractables. In regards to handling try not to directly handle PCB or contact points. For a graphics card try to handle it from the corners or the heatsink. For a motherboard use the corners / sides. If you do not want to use full gloves you can also consider finger ESD cods. If you use your bare hands just have common sense and keep in mind when the contacts are.
I mistakenly refer to the measurement on the gloves thickness as millimeters, when in fact it is milli-inches. MIL stands for milli-inches and MM stands for millimeters. My bad. Though, that doesn’t change anything I say as inaccurate regarding smaller number = thinner glove.
ESD Nitrile Gloves:
http://amzn.to/2rbxvVN
If you’re trying to prevent fingerprints, wash your hands thoroughly with soap and water, paying particular attention to scrubbing the pads on your fingers. Dry them off well. Then handle the components by the edges, as I demonstrate in all of my computer building videos. If you happen to see a fingerprint, stop. Go wash your hands again! This is a much better plan than using any kind of glove.
Remember, handle all parts by the edges and there is no place for fingerprints to be left behind! I demonstrate this in every single computer build video I’ve ever done.
If you’re trying to prevent cuts, these gloves are all too thin to provide any protection from that. Work slower and more carefully to avoid injury. Or put on band-aids prematurely in areas of your hands that you feel you are most prone to be cut.
Video editing software used to create this video:
Cyberlink PowerDirector 15 Ultimate:
https://www.cyberlink.com/products/powerdirector-ultra/
Screen captures by Camtasia Studio 9:
https://www.techsmith.com/camtasia.html
Questions?
https://www.facebook.com/careyholzmanfanpage
See more of Carey’s video’s here:
http://www.CareyHolzman.com
Hardened latex being removed from a stainless steel tank. The Blackwell’s Inc. associate is using a pneumatic air chisel with a 3 inch bit. The latex tank was cleaned down to bare metal.
