High Quality for 32″ Large cuff rubber glove sale to Paraguay

FAQ Content

Check out these new styles and more from Zappos.com! http://zps.to/ShopZappos
Subscribe & see more! http://zps.to/SubscribeShopZappos
Slope side or on the town, make an eye-catching statement in the JBU™ Whitney boot.
Microban® antimicrobial treatment in all JBU products helps keep odors at bay, and promotes a cooler, drier feel.
100% vegan-friendly construction.
Distressed synthetic leather and houndstooth textile upper materials.
Bungee and toggle closure.
Decorative buckle closures at top of shaft.
Heel pull loop.
Cozy textile lining offers a great in-shoe feel.
Contoured memory foam footbed supplies daylong comfort.
Non-marking, partially-recycled rubber outsole.
Imported.
Measurements:

Weight: 1 lb
Circumference: 14 1⁄2 in
Shaft: 12 in

Connect with Zappos:
Check out our other channel! https://www.youtube.com/ZapposGear
Follow Zappos on Twitter & Instagram! @zappos
Pin with us! https://www.pinterest.com/zappos
Be our friend on Facebook! https://www.facebook.com/zappos
Go Beyond the Box! https://www.zappos.com/blogs

Be cautious when holding key components that have sensitive contact areas. If you want to be extra cautious you can use tech grade ESD gloves. I recommend ESD Nitrile gloves that have microtextured fingertips that provide excellent grip on all surfaces. 100% nitrile gloves contain no natural rubber or silicone and meet stringent requirements for particles and extractables. In regards to handling try not to directly handle PCB or contact points. For a graphics card try to handle it from the corners or the heatsink. For a motherboard use the corners / sides. If you do not want to use full gloves you can also consider finger ESD cods. If you use your bare hands just have common sense and keep in mind when the contacts are.

I mistakenly refer to the measurement on the gloves thickness as millimeters, when in fact it is milli-inches. MIL stands for milli-inches and MM stands for millimeters. My bad. Though, that doesn’t change anything I say as inaccurate regarding smaller number = thinner glove.

ESD Nitrile Gloves:

http://amzn.to/2rbxvVN

If you’re trying to prevent fingerprints, wash your hands thoroughly with soap and water, paying particular attention to scrubbing the pads on your fingers. Dry them off well. Then handle the components by the edges, as I demonstrate in all of my computer building videos. If you happen to see a fingerprint, stop. Go wash your hands again! This is a much better plan than using any kind of glove.

Remember, handle all parts by the edges and there is no place for fingerprints to be left behind! I demonstrate this in every single computer build video I’ve ever done.

If you’re trying to prevent cuts, these gloves are all too thin to provide any protection from that. Work slower and more carefully to avoid injury. Or put on band-aids prematurely in areas of your hands that you feel you are most prone to be cut.

Video editing software used to create this video:
Cyberlink PowerDirector 15 Ultimate:

https://www.cyberlink.com/products/powerdirector-ultra/

Screen captures by Camtasia Studio 9:

https://www.techsmith.com/camtasia.html

Questions?

https://www.facebook.com/careyholzmanfanpage

See more of Carey’s video’s here:

http://www.CareyHolzman.com