Manufacturer for Household rubber glove S United States Factory
Short Description:
Sanitation glove, made of 100% natrual latex, length 32-36cm, textured palm for anti-slip, waterproof, anti acid and alkali, non-toxic. Mainly used for food processing, hotels, family kitchen, etc. Color: red, yellow, orange, rose, nude, etc.
Product Detail
FAQ
Product Tags
We keep improving and perfecting our products and service. At the same time, we work actively to do research and development for the new products. Manufacturer for Household rubber glove S United States Factory, As we are moving forward, we keep an eye on our ever-expanding product range and make improvement to our services.
Sanitation glove, made of 100% natrual latex, length 32-36cm, textured palm for anti-slip, waterproof, anti acid and alkali, non-toxic.
Mainly used for food processing, hotels, family kitchen, etc. Color: red, yellow, orange, rose, nude, etc.
FAQ Content
In this lifecasting tutorial video, we demonstrate how to use alginate to make a mold of a hand.
Step One: Measure and Mix
Mix Ratio: 1 part Alja-Safe to 1 part water by volume. Add first cup of Alja-Safe and begin mixing. Add second and third cups of Alja-Safe. Mix to a creamy consistency, no lumps.
Step Two: Pose Hand and Immerse Slowing into the Alja-Safe
Wet the model’s hand before placing it into the Alja-Safe. Keep hand 1/2 inch (1.27 cm) above the bottom of the container. Let Alja-Safe set for 8-10 minutes, until solid.
Step Three: Demold
Slowly and carefully remove hand. Removing the model too fast may result in a tear in the mold. Ready to cast.
Step Four: Casting into the Alja-Safe Mold with Smooth-Cast 300Q Ultra-Fast Urethane Resin
Apply Universal Release Agent. Dispense Part A. Dispense Part B. Combine both parts in mixing container. Mix thoroughly. Rotate mold to minimize air entrapment. Plastic will cure in less than one minute.
Step Five: Demold the Resin Casting
Perfectly detailed reproduction. Apply primer. Apply paint.
How long did it take to make the mold?
Start to Finish: 25 Minutes
How long did it take to make the casting?
Start to Finish: 15 Minutes
How much Alja-Safe was used?
Less than 1 lb (0.45 kg)
Use Your Imagination:
* Cold Cast Metal Effects
* Create Different Color Effects
* Clear Resin Effects (additional mold making & casting required)
Starter Kit Available at: http://www.smooth-on.com/Getting-Started-Li/c4_1219/index.html
Make It Now! with Smooth-On
http://www.smooth-on.com/
http://www.facebook.com/SmoothOn
http://twitter.com/SmoothOn
http://www.google.com/+smoothon
One option for teak oil: http://amzn.to/1QVZPmE
Turpentine: http://amzn.to/1VTcPrf
0000 Steel Wool: http://amzn.to/1L6E3Kx
Gloves: http://amzn.to/1VTcV2a
Beeswax: http://amzn.to/1VTd1XE
Video showing how to clean veneer or solid teak.
