Professional High Quality Rubber glove-household for New Zealand
Short Description:
Sanitation glove, made of 100% natrual latex, length 32-36cm, textured palm for anti-slip, waterproof, anti acid and alkali, non-toxic. Mainly used for food processing, hotels, family kitchen, etc. Color: red, yellow, orange, rose, nude, etc.
Product Detail
FAQ
Product Tags
Our company puts emphasis on the management, the introduction of talented personnel, and the construction of staff building, trying hard to improve the quality and liability consciousness of staff members. Our company successfully attained IS9001 Certification and European CE Certification Professional High Quality Rubber glove-household for New Zealand, Competitive price with high quality and satisfying service make us earned more customers.we wish to work with you and seek common development.
Sanitation glove, made of 100% natrual latex, length 32-36cm, textured palm for anti-slip, waterproof, anti acid and alkali, non-toxic.
Mainly used for food processing, hotels, family kitchen, etc. Color: red, yellow, orange, rose, nude, etc.
FAQ Content
The Middle School XC Runners from Camas, Washington all ran the 3-Course Challenge near Seaside, Oregon on a rainy and muddy day.
Be cautious when holding key components that have sensitive contact areas. If you want to be extra cautious you can use tech grade ESD gloves. I recommend ESD Nitrile gloves that have microtextured fingertips that provide excellent grip on all surfaces. 100% nitrile gloves contain no natural rubber or silicone and meet stringent requirements for particles and extractables. In regards to handling try not to directly handle PCB or contact points. For a graphics card try to handle it from the corners or the heatsink. For a motherboard use the corners / sides. If you do not want to use full gloves you can also consider finger ESD cods. If you use your bare hands just have common sense and keep in mind when the contacts are.
I mistakenly refer to the measurement on the gloves thickness as millimeters, when in fact it is milli-inches. MIL stands for milli-inches and MM stands for millimeters. My bad. Though, that doesn’t change anything I say as inaccurate regarding smaller number = thinner glove.
ESD Nitrile Gloves:
http://amzn.to/2rbxvVN
If you’re trying to prevent fingerprints, wash your hands thoroughly with soap and water, paying particular attention to scrubbing the pads on your fingers. Dry them off well. Then handle the components by the edges, as I demonstrate in all of my computer building videos. If you happen to see a fingerprint, stop. Go wash your hands again! This is a much better plan than using any kind of glove.
Remember, handle all parts by the edges and there is no place for fingerprints to be left behind! I demonstrate this in every single computer build video I’ve ever done.
If you’re trying to prevent cuts, these gloves are all too thin to provide any protection from that. Work slower and more carefully to avoid injury. Or put on band-aids prematurely in areas of your hands that you feel you are most prone to be cut.
Video editing software used to create this video:
Cyberlink PowerDirector 15 Ultimate:
https://www.cyberlink.com/products/powerdirector-ultra/
Screen captures by Camtasia Studio 9:
https://www.techsmith.com/camtasia.html
Questions?
https://www.facebook.com/careyholzmanfanpage
See more of Carey’s video’s here:
http://www.CareyHolzman.com
