Supply for Rubber shoe cover supply for Cairo

FAQ Content

Paint your brake calipers to keep them looking good and rust free. This video will give you the outline of what you would need to do to paint your own brake calipers. I go over the tools and supplies you will need, the different steps it will take to get a good finish and you can see what the results look like.

Here is the spray paint I used (It comes in other colors too): http://www.amazon.com/gp/product/B003CT4AKC/ref=as_li_tl?ie=UTF8&camp=1789&creative=390957&creativeASIN=B003CT4AKC&linkCode=as2&tag=chri0e2-20&linkId=PEV46MBCYCBOJ4CK

Paint Your Brake Drums:

How to change Front and Rear Brake Pads and Rotors: https://www.youtube.com/watch?v=lU6OKQxSg8U
How to bleed/flush your Brakes: https://www.youtube.com/watch?v=n1NvtUwfRJc
Paint Your Brakes: https://www.youtube.com/watch?v=djmDciOIuls
Drum Brake Replacement: https://www.youtube.com/watch?v=zJ_UXP6GWkwWheel Cylinder Replacement: https://www.youtube.com/watch?v=GIWYkCOPAQ0Chrysler
How to Replace a Brake Caliper: https://www.youtube.com/watch?v=nbdJGCi29nQ

**If the video was helpful, remember to give it a “thumbs up” and consider subscribing. New videos every Thursday**

-Website: https://www.ChrisFixed.com
-Facebook: https://www.facebook.com/chrisfix8
-Twitter: https://twitter.com/ChrisFixed
-Instagram: https://instagram.com/chrisfixit
-Subscribe Here: http://www.youtube.com/subscription_center?add_user=paintballoo7
-YouTube Channel: https://www.youtube.com/ChrisFix

Disclaimer:
Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.

Watch more Stains & Laundry videos: http://www.howcast.com/videos/402247-How-to-Get-Wrinkles-out-of-Leather-and-Suede

Keep your leather and suede looking its best and get the wrinkles out.

Step 1: Place cloth on
Place butcher paper, grocery bag, or cotton cloth over the wrinkled leather or suede.

Step 2: Heat iron
Turn the iron on low to medium heat, and place the iron onto the bag or cloth. Iron until the wrinkles have smoothed out.

Tip
Be careful not to overheat the fabric. Overheating can cause the garment to burn or become shiny.

Step 3: Hang
Hang up your leather or suede piece in the bathroom, if wrinkles remain. Keep the piece away from the shower, to protect it from any water that may splash out.

Step 4: Run shower
Run a hot shower and let the steam relax the wrinkles.

Step 5: Lay flat
Remove the article from the bathroom and lay it on a flat surface. Smooth out the wrinkles with your hands.

Step 6: Blow-dry the wrinkles
Blow-dry the garment if wrinkles still remain. Make sure to keep the blow-dryer moving to prevent damage to one spot.

Step 7: Store garment
Store the garment in a closet, but don’t fold it or put it in a bag — allowing air to circulate will make it less likely that your garment will wrinkle. Now put on that leather jacket and show it off!

Did You Know?
Studies by the Centers for Disease Control found a higher incidence of leukemia among populations living near tanneries, and other research has shown highly elevated cancer rates among tannery workers.