2016 China New Design Rubber glove-household Egypt Supplier
Short Description:
Sanitation glove, made of 100% natrual latex, length 32-36cm, textured palm for anti-slip, waterproof, anti acid and alkali, non-toxic. Mainly used for food processing, hotels, family kitchen, etc. Color: red, yellow, orange, rose, nude, etc.
Product Detail
FAQ
Product Tags
Our company puts emphasis on the management, the introduction of talented personnel, and the construction of staff building, trying hard to improve the quality and liability consciousness of staff members. Our company successfully attained IS9001 Certification and European CE Certification 2016 China New Design Rubber glove-household Egypt Supplier, "Create Values,Serving Customer!" is the aim we pursue. We sincerely hope that all customers will establish long term and mutually beneficial cooperation with us.If you wish to get more details about our company, Please contact with us now
Sanitation glove, made of 100% natrual latex, length 32-36cm, textured palm for anti-slip, waterproof, anti acid and alkali, non-toxic.
Mainly used for food processing, hotels, family kitchen, etc. Color: red, yellow, orange, rose, nude, etc.
FAQ Content
In this lifecasting tutorial video, we demonstrate how to use alginate to make a mold of a hand.
Step One: Measure and Mix
Mix Ratio: 1 part Alja-Safe to 1 part water by volume. Add first cup of Alja-Safe and begin mixing. Add second and third cups of Alja-Safe. Mix to a creamy consistency, no lumps.
Step Two: Pose Hand and Immerse Slowing into the Alja-Safe
Wet the model’s hand before placing it into the Alja-Safe. Keep hand 1/2 inch (1.27 cm) above the bottom of the container. Let Alja-Safe set for 8-10 minutes, until solid.
Step Three: Demold
Slowly and carefully remove hand. Removing the model too fast may result in a tear in the mold. Ready to cast.
Step Four: Casting into the Alja-Safe Mold with Smooth-Cast 300Q Ultra-Fast Urethane Resin
Apply Universal Release Agent. Dispense Part A. Dispense Part B. Combine both parts in mixing container. Mix thoroughly. Rotate mold to minimize air entrapment. Plastic will cure in less than one minute.
Step Five: Demold the Resin Casting
Perfectly detailed reproduction. Apply primer. Apply paint.
How long did it take to make the mold?
Start to Finish: 25 Minutes
How long did it take to make the casting?
Start to Finish: 15 Minutes
How much Alja-Safe was used?
Less than 1 lb (0.45 kg)
Use Your Imagination:
* Cold Cast Metal Effects
* Create Different Color Effects
* Clear Resin Effects (additional mold making & casting required)
Starter Kit Available at: http://www.smooth-on.com/Getting-Started-Li/c4_1219/index.html
Make It Now! with Smooth-On
http://www.smooth-on.com/
http://www.facebook.com/SmoothOn
http://twitter.com/SmoothOn
http://www.google.com/+smoothon
HexArmor Needle-Resistant PPE is proven needlestick technology used by some of the largest recycling and hospital waste companies in the world. Our needle-resistant gloves and arm guards are tested with actual needles to ensure maximum protection from needlesticks. Ask our customers of over 5 years- we are the most trusted source for needle protection.
