90% OFF Price For Isolater rubber sleeve to Stuttgart Factory

FAQ Content

Watch more Stains & Laundry videos: http://www.howcast.com/videos/402247-How-to-Get-Wrinkles-out-of-Leather-and-Suede

Keep your leather and suede looking its best and get the wrinkles out.

Step 1: Place cloth on
Place butcher paper, grocery bag, or cotton cloth over the wrinkled leather or suede.

Step 2: Heat iron
Turn the iron on low to medium heat, and place the iron onto the bag or cloth. Iron until the wrinkles have smoothed out.

Tip
Be careful not to overheat the fabric. Overheating can cause the garment to burn or become shiny.

Step 3: Hang
Hang up your leather or suede piece in the bathroom, if wrinkles remain. Keep the piece away from the shower, to protect it from any water that may splash out.

Step 4: Run shower
Run a hot shower and let the steam relax the wrinkles.

Step 5: Lay flat
Remove the article from the bathroom and lay it on a flat surface. Smooth out the wrinkles with your hands.

Step 6: Blow-dry the wrinkles
Blow-dry the garment if wrinkles still remain. Make sure to keep the blow-dryer moving to prevent damage to one spot.

Step 7: Store garment
Store the garment in a closet, but don’t fold it or put it in a bag — allowing air to circulate will make it less likely that your garment will wrinkle. Now put on that leather jacket and show it off!

Did You Know?
Studies by the Centers for Disease Control found a higher incidence of leukemia among populations living near tanneries, and other research has shown highly elevated cancer rates among tannery workers.

Roberto is in this video. After a short presentation of the company, he explains how trilaminate drysuits are produced.

Enjoy it and please comment below.

“My name is Roberto Scerbo
I’m the owner and founder of Rofos.
I founded this Company 32 years ago.
We started with gloves socks and wetsuits to me and to colleagues and friends who were doing competitive spearfishing.
These 25 years of competitiveness obviously gave to me a depth knowledge of neoprene using it personally.
The passion pushed us over the years to expand the range and the quality of products, widening of course also the headquarters becoming a benchmark in the diving industry.
In 2010 we decided to face a new challenge developing our first trilaminate drysuit dedicated to technical diving.
The manufacturing of templates begins with the selection of the fabrics and cutting the jigs in various sizes.
The real production begins with the cutting of the fabric and reinforcements.
In the early years we used to cut by hand.
Nowdays we introduced an electric cutter to maximize the precision.
At this time we proceed with the application of the dry zipper and the neck seal, until the fabric is still lying on the table to ensure an optimal application.
The third stage involves the application of the pockets and reinforcements by sewing and the assembly of the various pieces.
Then we proceed with the application of wrists and boots The heat welding is the key step to ensure the watertight integrity of the drysuit, so, obviously, we dedicate close attention this step.
Every single suit is then tested in a tank to control the effective sealing of each single seam.
The spirit of the Company is to continue to grow creating more and more performing and reliable products.”