Best quality and factory 24″ rubber glove with cotton linning-smooth finish Lahore Factory

FAQ Content

Crue Latex Catsuit
Kickstart hearts in this look that kills! This full body catsuit clings to every curve, and the fringed sleeves will show off your wild side!

http://www.honour.co.uk/crue-latex-catsuit.php

Back In Black Latex Body
Leave them thunderstruck and shake them all night long in this latex fringed body, with a zip up the back for ease.

http://www.honour.co.uk/back-in-black-latex-body.php

Maiden Latex Fringed Leggings
Hallowed by thy name in these skin tight latex leggings, whether its daytime or 2 minutes to midnight, these will be sure to cause a stir!

http://www.honour.co.uk/maiden-latex-fringed-leggings.php

Twisted Sister Latex Fringed Skirt
If you wanna rock, this skirt is the one for you become the leader of the pack in this sexy and shiny latex skirt, complete with fringing which accentuate every swing of your hips.

http://www.honour.co.uk/twisted-sister-latex-fringed-skirt.php

Leppard Latex Fringed Gloves

Cause hysteria in these fringed latex gauntlet gloves, a staple for the wardrobe of any vamp!

http://www.honour.co.uk/leppard-latex-fringed-gloves-l.php

Latex Tube Top

http://www.honour.co.uk/latex-rubber-tube-top.php

In this video, I show how to fix a common problem with the blower door actuator on a 2010 Ford F-150 XLT. Here is the part that I installed into the truck. http://amzn.to/2f0Vgue

2003- 2008 Blend Door Actuator Ford F-150

http://amzn.to/2oVwtNh

2009- 2014 Blend Door Actuator Ford F-150 (THIS IS THE MODEL I USED)

http://amzn.to/2f0Vgue

2015- Present

http://amzn.to/2qvKL4s

Dashboard Plastic Remover Tool:

http://amzn.to/2pVlmUE

Note: Make sure this fits within your model. I know its hard to find the parts sometimes, so I hope you use these links above as a guide to finding your actuator.

This F-150 would only blow cold air because the actuator for the blower door went out. Before I went this far to replace the part I started a few diagnoses: tested the air conditioner, went under the hood to see if the heater core hoses were hot, and check the internet if this was a common issue. Sure enough, every test lead to a faulty actuator.

The hardest part was jamming my hand through the glove box. In order to get to the 5/16in screw on the bottom, I had to go through the glove box while my left hand was in the dash to help assist. Once I got the screw out it was fairly simple.

Installing the new unit took a little bit of wiggling in there because the actuator and door need to be lined up. It can only fit one way. The gear is keyed for this reason. Once installed, connect the power cord, install the two screws that hold the unit down, and put the dash all back together.

This process took about 45 minutes to complete. After the install I was able to change from hot to cold with ease.

Thanks for watching:
Subscribe- http://goo.gl/nD3r4v
Like
Comment
Enjoy