Factory wholesale price for Isolater rubber sleeve for Seattle Factory

FAQ Content

Eastwood Blast Cabinet – Effectively Blast Large Vehicle Parts. The Eastwood Abrasive Blast Cabinet provide you with an effective abrasive blasting tool that is easy to assemble and has a large internal size.

Buy or Get More Info Here: http://www.eastwood.com/eastwood-abrasive-blast-cabinet.html?utm_source=youtube&utm_medium=annotation&utm_content=blast%20cabinet&utm_campaign=2014-09-29

Eastwood Blast Cabinet – Effectively Blast Large Vehicle Parts.

The Eastwood Abrasive Blast Cabinet provide you with an effective abrasive blasting tool that is easy to assemble and has a large internal size. This blast cabinet has an internal light, low volume, non-duning hopper design with a high flow 15” Hg blast gun. It also has a large top opening design that eliminates the need for side doors and allows you to settle the cabinet against a wall in a shop. Plus, it comes with replacement window liners and grip-textured gloves to ensure a secure grasp on all objects.

36” width by 23” height by 24” depth
Easy bolt design assembles in 2 hours with 2 people
Vacuum port designed for 1 1/2″ vacuum hose
Large 22” by 10.5” viewing window

The Eastwood Blast cabinet will allow you to get into areas you never could with a wire brush, wire wheel, sanding disc or stripping disc. Plus it gets the rust out of the pits, and when parts are properly cleaned, paint and powder sticks better and the finished parts look better. Plus, when you remove all of the rust, it won’t push back through and blister your paint.

Get yourself a blast cabinet today and do the job right.

Are YOU an Eastwood Guy?

In this lifecasting tutorial video, we demonstrate how to use alginate to make a mold of a hand.

Step One: Measure and Mix
Mix Ratio: 1 part Alja-Safe to 1 part water by volume. Add first cup of Alja-Safe and begin mixing. Add second and third cups of Alja-Safe. Mix to a creamy consistency, no lumps.

Step Two: Pose Hand and Immerse Slowing into the Alja-Safe
Wet the model’s hand before placing it into the Alja-Safe. Keep hand 1/2 inch (1.27 cm) above the bottom of the container. Let Alja-Safe set for 8-10 minutes, until solid.

Step Three: Demold
Slowly and carefully remove hand. Removing the model too fast may result in a tear in the mold. Ready to cast.

Step Four: Casting into the Alja-Safe Mold with Smooth-Cast 300Q Ultra-Fast Urethane Resin
Apply Universal Release Agent. Dispense Part A. Dispense Part B. Combine both parts in mixing container. Mix thoroughly. Rotate mold to minimize air entrapment. Plastic will cure in less than one minute.

Step Five: Demold the Resin Casting
Perfectly detailed reproduction. Apply primer. Apply paint.

How long did it take to make the mold?
Start to Finish: 25 Minutes

How long did it take to make the casting?
Start to Finish: 15 Minutes

How much Alja-Safe was used?
Less than 1 lb (0.45 kg)

Use Your Imagination:
* Cold Cast Metal Effects
* Create Different Color Effects
* Clear Resin Effects (additional mold making & casting required)

Starter Kit Available at: http://www.smooth-on.com/Getting-Started-Li/c4_1219/index.html

Make It Now! with Smooth-On

http://www.smooth-on.com/

http://www.facebook.com/SmoothOn

http://twitter.com/SmoothOn

http://www.google.com/+smoothon