Hot-selling attractive Household rubber glove-S for kazakhstan Factory
Short Description:
Sanitation glove, made of 100% natrual latex, length 32-36cm, textured palm for anti-slip, waterproof, anti acid and alkali, non-toxic. Mainly used for food processing, hotels, family kitchen, etc. Color: red, yellow, orange, rose, nude, etc.
Product Detail
FAQ
Product Tags
We insist on offering high quality production with good business concept, honest sales and the best and fast service. it will bring you not only the high quality product and huge profit, but the most significant is to occupy the endless market. Hot-selling attractive Household rubber glove-S for kazakhstan Factory, Contact with us today! We are ready for the market service now!
Sanitation glove, made of 100% natrual latex, length 32-36cm, textured palm for anti-slip, waterproof, anti acid and alkali, non-toxic.
Mainly used for food processing, hotels, family kitchen, etc. Color: red, yellow, orange, rose, nude, etc.
FAQ Content
In this lifecasting tutorial video, we demonstrate how to use alginate to make a mold of a hand.
Step One: Measure and Mix
Mix Ratio: 1 part Alja-Safe to 1 part water by volume. Add first cup of Alja-Safe and begin mixing. Add second and third cups of Alja-Safe. Mix to a creamy consistency, no lumps.
Step Two: Pose Hand and Immerse Slowing into the Alja-Safe
Wet the model’s hand before placing it into the Alja-Safe. Keep hand 1/2 inch (1.27 cm) above the bottom of the container. Let Alja-Safe set for 8-10 minutes, until solid.
Step Three: Demold
Slowly and carefully remove hand. Removing the model too fast may result in a tear in the mold. Ready to cast.
Step Four: Casting into the Alja-Safe Mold with Smooth-Cast 300Q Ultra-Fast Urethane Resin
Apply Universal Release Agent. Dispense Part A. Dispense Part B. Combine both parts in mixing container. Mix thoroughly. Rotate mold to minimize air entrapment. Plastic will cure in less than one minute.
Step Five: Demold the Resin Casting
Perfectly detailed reproduction. Apply primer. Apply paint.
How long did it take to make the mold?
Start to Finish: 25 Minutes
How long did it take to make the casting?
Start to Finish: 15 Minutes
How much Alja-Safe was used?
Less than 1 lb (0.45 kg)
Use Your Imagination:
* Cold Cast Metal Effects
* Create Different Color Effects
* Clear Resin Effects (additional mold making & casting required)
Starter Kit Available at: http://www.smooth-on.com/Getting-Started-Li/c4_1219/index.html
Make It Now! with Smooth-On
http://www.smooth-on.com/
http://www.facebook.com/SmoothOn
http://twitter.com/SmoothOn
http://www.google.com/+smoothon
This is a test to demonstrate Metal Roof Doctor’s [http://metalroofdoctor.com] Anti-Corrosion Protective Coating Systems against the corrosive environment cause by chlorination process of latex/rubber gloves making. Chlorine can be very corrosiove when it dissolves in water or wet air. Chlorine can form hydrochloric and hypochlorous (HOCl) acids easily with the existence of water. We provide 4 specimens in this test, 2 coated and the other 2 is un-coated. The coated rusted metal is still in good condition until the end of the test because of the protective coating shield, and we are confident that it wont corrode for a long time to come! Meanwhile the uncoated steel started to rust from the begining and fully rusted in the 4th day! Check Out this video to learn more! For Enquiry Call 019-475 7194 of Email sales@metalroofdoctor.com.
