Supply for 32″ Large cuff rubber glove to St. Petersburg Factories

FAQ Content

In this lifecasting tutorial video, we demonstrate how to use alginate to make a mold of a hand.

Step One: Measure and Mix
Mix Ratio: 1 part Alja-Safe to 1 part water by volume. Add first cup of Alja-Safe and begin mixing. Add second and third cups of Alja-Safe. Mix to a creamy consistency, no lumps.

Step Two: Pose Hand and Immerse Slowing into the Alja-Safe
Wet the model’s hand before placing it into the Alja-Safe. Keep hand 1/2 inch (1.27 cm) above the bottom of the container. Let Alja-Safe set for 8-10 minutes, until solid.

Step Three: Demold
Slowly and carefully remove hand. Removing the model too fast may result in a tear in the mold. Ready to cast.

Step Four: Casting into the Alja-Safe Mold with Smooth-Cast 300Q Ultra-Fast Urethane Resin
Apply Universal Release Agent. Dispense Part A. Dispense Part B. Combine both parts in mixing container. Mix thoroughly. Rotate mold to minimize air entrapment. Plastic will cure in less than one minute.

Step Five: Demold the Resin Casting
Perfectly detailed reproduction. Apply primer. Apply paint.

How long did it take to make the mold?
Start to Finish: 25 Minutes

How long did it take to make the casting?
Start to Finish: 15 Minutes

How much Alja-Safe was used?
Less than 1 lb (0.45 kg)

Use Your Imagination:
* Cold Cast Metal Effects
* Create Different Color Effects
* Clear Resin Effects (additional mold making & casting required)

Starter Kit Available at: http://www.smooth-on.com/Getting-Started-Li/c4_1219/index.html

Make It Now! with Smooth-On

http://www.smooth-on.com/

http://www.facebook.com/SmoothOn

http://twitter.com/SmoothOn

http://www.google.com/+smoothon

http://www.partselect.com/PS1146950-Frigidaire-134511600-Drive-V-Belt.htm?SourceCode=15 Click on below for a lot more info on this part, set up guidelines and a lot more.

This particular Drive V Belt is particular to Frigidaire made manufacturers including Gibson, Kelvinator, Tappan, White-Westinghouse, and Westinghouse. To obtain a drive belt particular to your design, stop by http://www.PartSelect.com.

If your washing device is obtaining any of these signs or symptoms, then replacing the drive belt could remedy your equipment problem.
one) Spin cycle not functioning appropriately
2) Smelled like burning rubber
3) Truly loud squeaking in the course of the spin cycle

PartSelect Section Amount: PS1146950
Frigidaire Section Amount: 134511600

Instruments used for this repair/substitution:
one) Putty Knife
2) Phillips Screw Driver

Get design-particular repair enable from PartSelect.com. Master how to troubleshoot, diagnose and repair your equipment with consumer-generated set up guidelines, hundreds of action-by-action repair movies, and our Quick Repairman. If you’ve received an equipment problem, we can enable http://www.partselect.com/Quick-Repairman.htm