Factory source manufacturing 14″ Household rubber glove Wholesale to St. Petersburg
Short Description:
Sanitation glove, made of 100% natrual latex, textured palm for anti-slip, waterproof, anti acid and alkali, non-toxic. length 36cm, 0.085kg/pair, packing: 100pr/case. Mainly used for food processing, hotels, family kitchen, etc. Color: red, blue, etc.
Product Detail
FAQ
Product Tags
We stick to the principle of "quality first, service first, continuous improvement and innovation to meet the customers" for the management and "zero defect, zero complaints" as the quality objective. To perfect our service, we provide the products with the good quality at the reasonable price. Factory source manufacturing 14″ Household rubber glove Wholesale to St. Petersburg, "Passion, Honesty, Sound service, Keen cooperation and Development" are our goals. We are here expecting friends all over the world!
Sanitation glove, made of 100% natrual latex, textured palm for anti-slip, waterproof, anti acid and alkali, non-toxic.
length 36cm, 0.085kg/pair, packing: 100pr/case.
Mainly used for food processing, hotels, family kitchen, etc. Color: red, blue, etc.
FAQ Content
http://www.trend-design.com.pl/en/12-normal-rubber-latex/21-superior-boots/superior-heels-boots-latex-100-poland-heels-20cm-2016-02-21–facts
In this video, I show how to fix a common problem with the blower door actuator on a 2010 Ford F-150 XLT. Here is the part that I installed into the truck. http://amzn.to/2f0Vgue
2003- 2008 Blend Door Actuator Ford F-150
http://amzn.to/2oVwtNh
2009- 2014 Blend Door Actuator Ford F-150 (THIS IS THE MODEL I USED)
http://amzn.to/2f0Vgue
2015- Present
http://amzn.to/2qvKL4s
Dashboard Plastic Remover Tool:
http://amzn.to/2pVlmUE
Note: Make sure this fits within your model. I know its hard to find the parts sometimes, so I hope you use these links above as a guide to finding your actuator.
This F-150 would only blow cold air because the actuator for the blower door went out. Before I went this far to replace the part I started a few diagnoses: tested the air conditioner, went under the hood to see if the heater core hoses were hot, and check the internet if this was a common issue. Sure enough, every test lead to a faulty actuator.
The hardest part was jamming my hand through the glove box. In order to get to the 5/16in screw on the bottom, I had to go through the glove box while my left hand was in the dash to help assist. Once I got the screw out it was fairly simple.
Installing the new unit took a little bit of wiggling in there because the actuator and door need to be lined up. It can only fit one way. The gear is keyed for this reason. Once installed, connect the power cord, install the two screws that hold the unit down, and put the dash all back together.
This process took about 45 minutes to complete. After the install I was able to change from hot to cold with ease.
Thanks for watching:
Subscribe- http://goo.gl/nD3r4v
Like
Comment
Enjoy